Tag Archives: plumbing

4 Drain Practices to Throw Down the Drain

View of the drain in the sinkProper etiquette is not only applicable in a professional setting. They have to be observed in every aspect of our lives and make our lives better and easier. This also applies when it comes to using the drains in our homes.

Read on to know what not to do:

Don’t Use Unclogging Chemicals

When faced with a drain clog, you will get many bits of advice from friends and relatives. One of them is likely to be to use chemicals to unclog your drain. However, all professional cleaners in Salt Lake City advise against it. This is because most of these substances cause corrosion to your pipes and could make them leak afterwards. Instead, invest in a drain snake or just call a professional plumber to have a look at it.

Never Pour Grease Down the drain

When you pour hot grease down the drain, it will initially flow. Afterwards, it will cool down in the pipes. From there, everything that comes into contact with it sticks and causes major clogging.

Never Rinse Joint Compound Down the Drain

Avoid rinsing cement, mortar mix, grout, or concrete down your drain. The chemical reaction will make them harder under water. This will culminate in a severe clog in your pipes that will be difficult to deal with. Sand is bad too since it settles quickly in traps and pipes to form clogs.

Do Not Throw Food Remains Down Drains

Many homeowners tend to throw and force food remains down the drain. However, this could cause clogging no matter how small the food pieces are. This is because the water cannot dissolve the food particles, so they are likely to remain in your pipes. Instead, throw any food remains in your garbage disposal. As a rule of thumb, anything that remains on top of your drain strainer belongs to the garbage disposal.

Follow these steps so your home can have a well-functioning drain system. These would also help you avoid having to shell out money to have your drain repaired.

Caring For Your Plumbing: Three Things To Remember

Plumber Talking To A Woman About The Plumbing System Of A Sink

Plumber Talking To A Woman About The Plumbing System Of A SinkTo make sure your plumbing system works the way it should, it helps to remember that this is a complex network of pipes and drains, water supply lines and sewer lines, pressure and heating. Faucets, toilets, sinks and others are not independent of the system. They all have a role to play, and you shouldn’t force them beyond their scope.

Going the DIY route when dealing with plumbing issues is not wise, as you can cause more damage. Let a plumber in Park City address these problems. But keep the following points in mind to make sure you play your part in caring for your plumbing system.

Leftover Food Belongs in the Bin

Before putting your used dishes in the dishwasher or the sink, scrape leftovers into a trash can. It’s tempting just to dump all the leftovers down the garbage disposal, but doing so can damage it in the long run.

Hair Can Clog Your Toilet

Your toilet is not a bigger waste disposal unit. It’s a good habit to pick up the hair on the bathroom floor and in the tub, but don’t flush it down the toilet. Doing this can clog your toilet just as bits of soap and toilet paper can.

Grease is a Serious Cause of Clogging

Do not pour cooking oil down the drain. Over time, cooled oil or grease solidifies and can form a barrier in your drain. This is a common plumbing problem. Put the oil in a disposable container and throw it out with your regular garbage. When oil solidifies, you can just throw it into the bin without putting it in a container. If you use good quality cooking oil, you can reuse it for frying several times before throwing it out. An oil recycling center in your area might accept your used cooking oil, too.

The more you know about what can cause plumbing problems, the better you can be at avoiding them. Keep these tips in mind as you go about your daily tasks.

3 Factors You Must Consider When Choosing Plumbing Services in Nelson

Plumber facing the camera ready to hear your concernsSometimes, you get so busy with a lot of duties that by the time you notice there is a need for plumbing services in your construction project, it is very late, and you begin your search for a plumber in a hurry. It is never advisable to wait until these last minutes to start looking for a plumber, or any other professional related to your construction project.

The process of finding the right plumbing services in Nelson should not overwhelm you. There are key factors you need to look out for that will make your search fast and easy. These include:

Experience, professionalism and appropriate licensure

Confirm that the plumbing contractor has a consistent record of providing expert services to their clients. It is also advisable you work with one that has years of experience in the industry. Beware of companies that warrant their services for a period longer than the time they have been operational. Another important check is to confirm whether they have appropriate licensure to operate in your area.

Large, skilled workforce

There are benefits you will only enjoy by working with a plumbing company that has a large and qualified workforce. For one, they get to complete the project you assign them on time. Secondly, they will meet your plumbing needs with the level of expertise that the tasks demand.

Timely services

If from your research and referrals you determine that a plumbing company has an excellent record of meeting their set deadlines, then you have found the right team. It is also important to check if they can work with tight deadlines and on emergency cases, as well.

Consider the above three factors when shopping for plumbing services in Nelson, and it will help you find the right plumber faster and with ease. In turn, you can focus more on the other aspects of your construction project.

6 Factors That Affect the Cost of Water Damage Repair

water damage repair in Salt Lake CityWater damage repair companies often give hugely varying estimates. If you’re in need of water damage restoration services, it then helps to understand how contractors price their jobs. According to allhoursplumbingslc.com, there are six factors that influence how water damage repair companies in Salt Lake City prepare cost estimates.

Water/Moisture Type

Typically, moisture sources have three categories:

  • Category 1 sources – This is clean water that poses no health risks. Category 1 sources include rainwater and clean tap water.
  • Category 2 sources – This is gray water that contains potentially toxic physical, chemical, or biological agents. Gray water sources include kitchen waste water and discharge from appliances, such as washing machines.
  • Category 3 sources – This is black water that is highly toxic and completely unsanitary. These sources include sewage and ground flooding water.

Cleaning up Category 2 and 3 water types require more effort, specific chemicals, protective equipment and gear than cleaning up Category-1 water type. Naturally, companies charge more when dealing with gray and black water. The color and odor of the water would immediately tell you what type is leaking out of your home or pipes.

The Size of the Affected Area

Contractors often bill by the square foot. Logically, the more the problem spreads, the more expensive it becomes. Try to contain the damage as early as possible.

The Extent of the Water Damage

The scope of the damage will also affect the cost of the repair. Bigger damages entail higher costs. For instance, repairing a water-damaged ceiling that is caving in will naturally cost you more than fixing a small leak.

The Materials Involved

The type of materials the contractor will work on also influences pricing. For instance, wood flooring may have a different price from concrete or carpeted flooring.

Duration of the Job

Water damage repair professionals in Salt Lake City often charge an hourly fee for their labor. This also depends on how long the repair job will take. The duration all depends on the material and extent of the damage, and this will affect the overall cost.

Amount of Water to be Extracted

Contractors need to consider the amount of still water that needs extraction. Usually, the more water that needs to be removed from the affected area, the higher the cost.

Cost is a key consideration in any water damage repair job. As a homeowner, you should understand how contractors prepare estimates, so you would know if you’re getting a fair price for the restoration work.

How Hydro Jetting Can Resolve Your Plumbing Issues

Plumbing Services in UtahIf you’re experiencing recurring issues with your plumbing, it’s high time you call in the pros to have your system inspected. Water pressure issues and clogged drains are usually indicative of more severe plumbing issues and a professional plumber will know what exactly your system needs and if hydro jetting is the way to go.

What Exactly is Hydro Jetting?

Hydro jetting uses high-pressure water flow to more thoroughly scour your plumbing pipes’ interior surfaces to eliminate grease, scale, and other debris accumulation. To start the hydro jetting process, your plumber will insert a hose connected to a water tank into your pipe. This special hose is capable of withstanding highly pressurized water. Your plumber will also use a special device for pressurizing the water that will be sent to your pipes. In contrast to rodding where a tool is used for penetrating debris buildup, hydro jetting gets the same result by using a more comprehensive cleaning process.

Hydro Jetting Done Right

The method of eliminating buildup via hydro jetting significantly relies on gravity. Many home plumbing systems make use of gravity for pulling wastewater out of your pipes and into the sewer system. The hydro jetting tool functions from the bottom and works its way up, explains a professional plumber offering hydro jetting service in Utah.

According to Beehive Plumbing, on the other hand, once it’s inserted into your plumbing system’s downstream, it will start moving upstream and as water cleans your pipes, all accumulated debris will be forced downward and flushed out of your plumbing system.

Done properly, hydro jetting could really resolve even the most persistent plumbing issues and could even fix scale and mineral accumulation in sewer drains, as well as infiltration of tree roots.

Note that your plumber must be capable of determining the most accurate water pressure needed for the job since this will greatly differ according to your pipes’ condition. Otherwise, you’ll be in for more plumbing issues.

Reduce Your Plumbing Bill with 3 Steps

Plumber in NZBy proper maintenance of the system it will give you service for longer and provide the family with clean water throughout the year.  Without proper care, repair and replacement costs can mount up and be too much in the end. But you should not worry, with the few steps below you will be capable of reducing plumbing related expenses.

Reduce the Pressure in the Pipes

There are pipes that run throughout the house as they deliver clean water in the house and remove waste from the house. They are hard to access and this makes servicing them quite expensive. If there is high pressure running through the pipes can strain the pipes and consequently reducing their life time. Purchase a hose bib gauge from your local store and this will help you check the pressure in the pipes. If the pressure is high, hire a professional plumber to install a pressure reducer.

Be Careful What You Put Down the Drain

Most drains get blocked because the homeowner tossed things that do not belong there. If you are not sure if something should be in the drain it will be a safer bet to throw it in the trash. The sink disposal is only capable of handling soft foods and not hard items such as egg shells. Pouring down hot grease in the drains could be a terrible idea. Do not forget to never flash things down the toilet.

Soften the Water

Hard water has a high mineral count and has particles. They build up on the faucet filters over time and could cause blockages. If you have this problem, you can invest in a water softener that is electric. It should be installed by a professional who can also handle your concerns with your central heating in NZ.

In these hard financial times, it is important to keep your costs as low as possible. With the steps above you could keep your expenses at a minimum.